Installation Steps for Standard Temporary Fencing

Installation Steps for Standard Temporary Fencing

(e.g., Steel Mesh Panels for Events/Construction)

Materials/Tools Needed

• Fence panels (typically 2–3m wide × 1.8–2.4m high, galvanized mesh or weldmesh).
• Star pickets (U-posts) or base plates (for freestanding panels).
• Fence clips or zip ties (to attach panels to posts).
• Sledgehammer or post driver.
• Spirit level, tape measure.

Step-by-Step Process

1. Plan Layout:
   • Mark fence boundaries with spray paint/chalk.
   • Check for underground utilities (dial 1100 in Australia for free service).
2. Install Star Pickets (if using posts):
   • Drive star pickets into the ground every 2–3m using a sledgehammer.
   • Depth: 30–50cm (ensure stability).
   • Use a spirit level to keep posts vertical.
3. Attach Panels:
   • Slide panels between star pickets.
   • Secure panels to posts with fence clips, wire ties, or bungee cords.
   • For freestanding panels: Attach weighted base plates (e.g., concrete feet or sandbags).
4. Add Stability:
   • Diagonal braces: For long runs or windy areas.
   • Guy wires: Anchor end panels to ground stakes.
   • Sandbags: Place on base plates for extra weight.
5. Gates/Access Points:
   • Install temporary swing gates or removable panels secured with latches.
6. Safety Checks:
   • Ensure no sharp edges or protruding parts.
   • Add safety bunting (high-vis tape) for visibility.